Random noise artifacts on 3 axis

[Jakub87]

Hi guys,
first of all, thanks for the great procuts you are developing! Such a joy to use. I own following unit with following firmware currently (for approx. 2 years or so):
Product Name: VKBsim Gunfighter MCG Pro Twist
PRO version
T-Link supported
Firmware version: v2.199

Reason i am reaching out is a strange issue i am getting since 1 month or so.

When moving axis X and Y (roll and pitch), i sometimes get strange noise on axis Z, slider 2 and HAT at the same time. It basically goes to max for a fraction of a second. I have used the VKB Joytester to confirm and log the issue. See attached image.

Is there any way to resolve this by software? Do you know what this could be?

[fallout9]

Run that test again with only 1 axis checked in tester at once to see which axes are spiking. Also, flash to the latest firmware, reset to default and recalibrate beforehand.

[Jakub87]

Hey Fallout9, thanks for your feedback.
The fw is already the latest i can find on your website. Did the default reset and calibration and rerun the test again with all axis individually. See below the ones that actually triggered (i have only moved x and y again, all others were untouched in all tests). Any setting or so i could try to get these peaks out? some smoothing or so maybe?

[Victorus]

Step1. Check X axis, uncheck Y.
2. Move grip. Register outputs.
3.Check Y axis, uncheck X.
4. Move grip. Register outputs.
May be it will allow to find axis - error source.

[Jakub87]

Seems to be X causing issues, see below

[Ron61]

Show the Global-External, Profile-Axes tabs from the configurator and attach the profile (in the archive) to the message.

[Jakub87]

here it is, thanks for looking into this

How do i put the cfg file into archive? where do i find this

[Ron61]

Try the latest firmware and the configurator from here.
In the Profile-Axes tab, you are interested in the logical and physical axes sections. The profile file is usually located in the configurator folder when saving to disk using the Save button. This is what you need to archive and attach to the message.

[Jakub87]

Ok thanks, got it. But this is a CFG file which i am unable to upload here into the forum. Is there any other way to share with you