seperating modules of stecs standard throttle

[skidkid]

first post and maybe stupid question, but from the modular looks of it, i guess its possible to divide the two "modules" of the stecs standard throttle to put the stem module in front of the throttle levers onto my UCM, similar like its shown in below's picture, just without the "mini plus" module. im asking if such a setup is possible without DIY and warranty loss, as this way, the setup wouldnt reach as far out from the desk as its now with the default standard stecs setup, which would make it possible to place it in a more comfortable position

[fallout9]

So you have a STECS Standard and UCM and want to unlink the STEM from the front of STECS and install it in vertical position? If yes, then it is possible, but you'll need some more parts:
- STEM back cover;
- STECS Mini UCM adapter plate;
- USB C cable.

[skidkid]

thx, thats exactly what i needed to know.

[skidkid]

ok, so i basically achieved what i wanted, and have now both the stecs and the stem seperately mounted on my UCM.
but i doubt to have mounted it correctly, as the stem module is only held by two screws to the UCM.
is that how its supposed to be?