T Rudder. Config software Find&Configure does not show

[jusu]

I got new T Rudder pedals. I'm using latest Config v0.92.33 software and latest firmware for VKB NXT R +THQ XT2 v. 2.115 and TRudder XT2 v. 2.115.
Config software does not show Find&Config button. External devices Tab shows Generic device instead of T Rudder as in my attachment picture.

Jusu

[fallout9]

The Find&AutoConfig button is specific only to NXT line.
For the rudders just press Default button, then calibrate, this should get them prepared for gaming.

[jusu]

I also tried to set a vkb nxt button for the virtual brakes in T-Link, but it does not seem to work. I did all the default and calibration stuff but to no avail. If I use a keyboard key instead, it works all right, as does the test button in T-Link. I also have a THQ module in my vkb nxt.
Luckily Il 2 GB and Blitz do not need T link, but I'd still like to have a solution for this.

Jusu

PS Thank you for the swift answer

[fallout9]

There are some issues at the moment with T-Link and NXT modules. Until they get fixed I suggest to map a button on your module to a keyboard key and use that as virtual brakes modifier.