I have tried my best on the VKB configurator to make them all appear and assignable, like this
EDIT I uploaded the wrong photo here, where I set axis 7 to Vmars instead of Dmars like Ron61 pointed out below. I have made corrections accordingly.
With this arrangement all my 3 axes are recognized and movable BUT the twist axis, configured to be shown as "Rot X" just will refuse to go register its full range of motion. In other words, when I twist it fully rightward, this is what shows up on the axis test
As you could see, the Rot X axis simply will not go any further right despite me twisting my stick to the end of its physical limit in that direction. Of course I have done calibration.
Now however, if I were to make this small modification as shown here
EDIT my mistake, I should have circled the #7, not the #8
Then that twist axis will just take the place of the rudder axis (axis 7, configured as "Rot Y") and WILL be able to move its full range of motion (under the name "Rot Y"), as shown here
Now, it would be so nice if I could use my original arrangement but make the twist axis register its full range as intended. I have lost a few grams of braincells doing trial and error to resolve this and have chosen to conserve what's left of my sanity to read the DCS manuals. Any help would be warmly appreciated.
Or I'm basically fine with any way for me to use all of my axes to their full ranges of motion.
Please help. My brain is begging me to stop torturing myself with this little bug
