MCG - LED active based on virtual mouse active/virtual mouse curve

[HooverinSchneef]

I have the virtual mouse set up on the left-most (Gate Cont) ministick on my Modern Combat Grip in uSSw Tempo mode. How do I get the LED to light up green when the mouse mode is active?

I tried copying the POV mode LED on the "Master Mode" ministick to Gate Cont and changing the event to "Mouse active" but that didn't seem to work.

Also, how do I change the curve/sensitivity of the virtual mouse?

[fallout9]

Post a screenshot with your LED settings.
Which cell number lights up in Profile/Buttons/Physical layer when clicking the center button of the GateCont ministick with the Poll option activated?

[Victorus]

Check mouse mode. Global - Common - Mouse. On/off or Always On. Mouse works properly?

[HooverinSchneef]

Not at home but I jerryrigged a screenshot of the LED setup from the manual:

Same thing with the physical button layer. I believe it's this cell marked "Tempo POV2".
If it helps, I think POV1 is in the cell to the right of POV2 cell.

If this isn't enough, I'll post actual screenshots when I get home later.

Thanks!

[HooverinSchneef]

Check mouse mode. Global - Common - Mouse. On/off or Always On. Mouse works properly?

Yes, mouse works properly, and I'm able to switch from mouse mode to what I'd assume is POV mode with a long press of the stick, but I don't see the POV buttons in the software. I'm not sure where the inputs are going when the stick isn't in mouse mode.

I also have 2 POVs selected in Global -> Common, so POV2 appears on the Test tab, but no inputs are being registered in the Test tab

[HooverinSchneef]

Post a screenshot with your LED settings.
Which cell number lights up in Profile/Buttons/Physical layer when clicking the center button of the GateCont ministick with the Poll option activated?

Line 1, Reg 5

[HooverinSchneef]

Check mouse mode. Global - Common - Mouse. On/off or Always On. Mouse works properly?

Yes, mouse works properly, and I'm able to switch from mouse mode to what I'd assume is POV mode with a long press of the stick, but I don't see the POV buttons in the software. I'm not sure where the inputs are going when the stick isn't in mouse mode.

I also have 2 POVs selected in Global -> Common, so POV2 appears on the Test tab, but no inputs are being registered in the Test tab

Just kidding, it's the axis mode