Issue: Twist (Rot Z) and Analog ministick (Rot X & Y) either 0% or 100%

[coogrrr94]

I have a Gladiator NXT. I just updated to the latest firmware but am still having the issue.

My issue is with the twist and ministick not acting as axes, they are either all or nothing. I was wanting to use the twist axis of the joystick for the rudder in Rise of Flight.

I have attached screenshots of the Axes Profile.

Any and all help appreciated, thanks.

[fallout9]

Please follow this walkthrough from point 7.

[coogrrr94]

Thanks, just followed the instructions. Issue still persists. I posted new screenshots, post completion of the calibration. I noticed an Err-Stat Active under the picture of the joystick, don't know if that means anything.

Thanks again.

[coogrrr94]

Here's the Physical axes screenshot.

[fallout9]

They look good, have you tried in a tester?

[coogrrr94]

Yes, the Rot Z will go from 32767 to 0 when twisting left and 32767 to 65535 when twisting right, no middle ground all or nothing? Same with the mini stick still too.

Thanks for trying to help.

[fallout9]

Please follow each step of the following:
1. Click the Default button under Tools tab;
2. Navigate to Global/Devices/External Devices and press the Find&AutoConfig button;
3. Go to Test/Axes1 tab and click on the Start Calibr button;
4. Move your pitch, roll and yaw axes all the way, slowly at the end;
5. Move the mini-throttle up and down;
6. Press the A1 ministick center button and when the LED turns red move the ministick all over;
7. Press the End Calibr button.

[coogrrr94]

Followed all those steps and still have the issue.

[fallout9]

Please post a screenshot showing Global/External/ExternalDevices chart.

[coogrrr94]

Is the issue that it is only showing 4 Axis instead of 8?

[fallout9]

Everything looks well. Could you run the VKBDevCfg, go to Test/Axes1, put the joystick in front of your screen, show the issue while recording a movie? Post the Unlisted YT link afterwards please.

[coogrrr94]

https://youtu.be/-H9d9D5Czdo

[fallout9]

Unzip the attached file and flash it following the walkthrough posted above.

[coogrrr94]

This warning message pops up, should I click Yes or No?

[fallout9]

Yes please, follow the instructions on screen. Do not ever try to calibrate the device with anything else other than the native software.