Gladiator NXT: Mouse Mapping to Mini-Stick / No Axis

[Ancient]

Working and reading so far I get. If I get it, there should be axis to select for the mouse control by default. I've no one right here. I started from default settings. Any idea?

[Ron61]

Mouse axis settings have moved to the Povs-Output tab.

[Victorus]

Look here viewtopic.php?f=25&t=5437&p=47626&hilit=mouse#p47626

[Ancient]

Ah, damn it. I've seen this thread but didnt follow it long enough.

So, everything looks fine. Per default the Mouse is bound to Axis X/Y 5/6, which is the #ID of RotX and RotY, which are the Axes of the Ministick in Ministick Mode. Mouse active is set to "always" in Global and POV screen.

I am not sure if this should be enough. If I've got it correctly in Ministick-AXIS mode I would not need to Map buttons to the Mouse-Axi ( I also tried this and managed to Move the Mouse via Buttons, but I want it to have it on the Ministick Axis Mode?).
Do I need to change something else on the Axes tab perhaps?

I am really sorry. And YES I've the documentation and check the mouse settings...no idea however what step I am missing.

[Ancient]

To keep the status updated:

Upgrading the SCT Firmware from v2.025 to XT v2.050 did the trick immediantly. I'am not completly stupid over all. No other settings are required other than Global/Mouse and POV/Mouse.

What I dont understand yet:

With Global/Always on and POV/On-Off the Mouse is works when the Ministick is in POV mode. When I switch to Axis mode (Red Light) it is disabled (the Stick works in Axis-Mode sending RotX/RotY).
When I change both settings to Always it works in both modes, effectively disabling the Mode switch.

I thought and I wanted it to be reverse, so switching to Axis-Mode (red light) actives the Mouse-Mode. Is this possible to achieve.