Assistance needed 2 devices- MCG Ultimate + T-Rudder

[Deadstick]

Hello all, I'm guessing this is an easy one, but I'm having problems getting my MK2 blackbox to see both my gunfighter ultimate and T-rudder mk4 to be seen by the VKB software at the same time. I can only flash one or the other. I feel this is something I'm overlooking. Any advice or assistance is greatly appreciated. If I need to add the second MK2 black box I can do that.

[Victorus]

Flash as gunfighter ultimate. Have you twist? What do you see at Test-Axes tab? Show screenshots of axes parameters (physical and logical).
viewtopic.php?f=25&t=2762

[Deadstick]

Hello and thanks for the response. Yes I have twist. This is the latest Gunfighter Ultimate design, just recently purchased. See comments below.

1 - Device model and version- Model is Gunfighter Ultimate MCGUTw March 2021
2 - Controller Firmware version- VKB Device COnfig v0.91.78 (Njoy32 firmware v2.03.0)
3 - Number and type of springs used - Two # 20's both X & Y axis
4 - Тype of cams used- Factory Cams-
5 - If VKB original software is used, please always mention its version- See Comment 2
If the question is in regards to joystick/pedals axes, please additionally post: -
6 - Vkbjoytester screenshots. Download it here: http://ftp.vkb-sim.pro/Programms/VKB_JoyTester.zip
7 - Vkbdevcfg-c screenshots. Download it here: http://ftp.vkb-sim.pro/Programms/; make sure you're downloading the newest version.
Altogether 7 (seven) points. Please do not omit any.
Posting screenshots is crucial. We need to see what is happening. Please upload the images to our server.
We are not following external links and not downloading archives from whatever file depositories.
Following these directions will help us help you faster.

[Victorus]

Try to press Default button. Usually - for other grips with twist - SCG, F14 - twist occupies axis#5 Rz, V-Mars type. By default T-Rudders use axis#7, Z - D-Mars.

[fallout9]

Also note that if you're plugging both grip+base and rudders in the same Black Box only the main device would show in configurator (grip+base). To combine a MCG Pro or U with twist module together with the rudders would require to either lock the twist axis and use the rudders axis instead (you would have to re-flash the non-twist firmware to your base+grip in this case), or to cancel one of the existing axes (like one from one of the ministicks) and replace it with the rudders' axis.

[Deadstick]

Gentlemen,

Thank you both for your assistance. The problem is solved. The fix was solution 2 from Victorus. I apologize if there was initial confusion if I didn't state clearly that I was using only the one black box. Physically locking the twist axis on the grip, then reflashing with the non twist firmware (even though I have the twist variant) resolved it.

What I found odd is many of these Youtube Videos I've seen, clearly had shown multiple devices connected. Immediately I though somewhere, somehow there was some sort of logic confliction. Whatever the rate, it has been resolved. Much appreciate from both of you and Fallout. I apologize if I hadn't made myself more clear on the front end.

Respectfully,

Mike (Deadstick)