SCG-L A1 programmation after replacement

[OldGangster]

On my SCG-L grip, if I replace the A1 ministick with the hat switch provided, do I necessary have to restore original config with "default" button ?
In this case I suppose all my programmation will be lost ?
But the only thing that needs to be resetted is the programmation of the A1 ministick mode, as the others stays identical, including the actual POV mode of A1.
Is there a way to do it ?
Trying to be more clear, what is the procedure to follow before and/or after replacing the A1 to keep all my programmation except the one of the ministick ?
At least,is there a way to print the actual programmation ?

Thanks you for your clarification and help

[fallout9]

You don't need to reset to default, just recalibrate (as every time when you change springs or cams, adjust dampers or swap grips). You could also save your profile to have a backup.

[OldGangster]

Simpliest is always better.
And yes I've already saved my profiles. Just wondering what happens with ministick programming when it comes to a POV.
I will have another question, but I've to investigate and test a little bit further before.
And try to clearly translate my mind, cause even if were are far cousins, English is not my native language (I'm from Moliere's country).
Thanks for the help.

[Victorus]

At least,is there a way to print the actual programmation ?

Try to press Device Report button on Tools tab. You will see FastReport printable document with joystick controls assignment.

[OldGangster]

OK, thanks a lot.