I recently reflashed my MCG Ultimate to firmware 2.09. After calibrating, my z axis is stuck at max value. I don't have a twist adapter, so I shouldn't even have a z-axis. Can this be safely ignored or is there something else I missed?
MCG Ultimate Calibration
Moderator: AdminGroup
MCG Ultimate Calibration
Hello all,
I recently reflashed my MCG Ultimate to firmware 2.09. After calibrating, my z axis is stuck at max value. I don't have a twist adapter, so I shouldn't even have a z-axis. Can this be safely ignored or is there something else I missed?
I recently reflashed my MCG Ultimate to firmware 2.09. After calibrating, my z axis is stuck at max value. I don't have a twist adapter, so I shouldn't even have a z-axis. Can this be safely ignored or is there something else I missed?
-
fallout9
- Posts: 5447
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 222 times
- Been thanked: 1266 times
Re: MCG Ultimate Calibration
Yep, don't worry about that. Considering that you flashed the 'no twist' firmware, then that axis is dead, even if it's still showing up in tester.
Who is online
Users browsing this forum: No registered users and 17 guests