Firmware/Flash Issue with POV2

[mlbosox]

Hello,

I just received the MCGU and followed all of the instructions in the manual and the YouTube video. I made sure to grab the correct file from the bootloader. Once I got to the "Test" tab I noticed that only one POV symbol was listed - but the video had both red and blue POV showing. Clicking the ministick that came already installed shows button 32 activating. The Axis page shows movement left-to-right and up/down. I am also unable to bind anything to the ministick (besides button 32) within DCS. I tried resetting the blackbox and starting from scratch, but same results. During training missions with the SU-33, the green light on the stick turn white and then back to green - not sure if this is related. I do have a second blackbox that came with the rudders - I can try starting over with it but wanted to check here before attempting. Screen shots attached. Any help is appreciated!

-Gunfighter MCG Ultimate & T-Rudders Mk.IV
-2x #30A Springs
-Avia S Cams
-Firmware: v2_02_5(2)
-VKBDevCfg: v0.91.78
-ZBootloader: v1.18

[fallout9]

There are 2 different matters: first, the light, if you haven't changed the LEDs programming, could mean imperfect contact between grip and base (reseat the grip) or not enough power (connect the joystick directly to computer).
Second, the default settings for MCG Pro/U grips is 1 POV only. If you want to program the other ministick as POV follow this resolve.