z-axis not working on Gunfighter Mk 3 SCG

[Tas]

Hello,

Just recently received my gunfighter and SCG, and I am having an issue setting it up for use.

I have followed all of the instructions and download the VKBDevCfg-C and ZBootloader-C, as well as the _Blackbox_MK2_GF_SCG_v2_00_7 file.

I was able to test and use both the Y and X axes, but the z- axis is not responding to the test/calibration in the VKBDevCfg-C program. I also downloaded and ran the joy stick tester from the VKB website, and it had the same result of both Y and X axes working, but not the Z-axis.

Am I missing a step, or does it just not work?

[Victorus]

Try to calibrate all axes. Please show screenshots of External devices tab, physical and logical axes tabs.

[Tas]

I hope that is what you are looking for. Not sure what you mean by physical and logical axes. I have been trying to calibrate the controller.
The red and black lines are the X and Y axis responding to the joy stick tester tool. Note that there is no blue line, which should be the z axis?

[fallout9]

Most probably the grip haven't been correctly installed. Please see this guide for proper installation.

[skypickle]

also make sure to recalibrate exactly as instructed here:

viewtopic.php?t=2853

[Victorus]

I hope that is what you are looking for. Not sure what you mean by physical and logical axes. I have been trying to calibrate the controller.
The red and black lines are the X and Y axis responding to the joy stick tester tool. Note that there is no blue line, which should be the z axis?

Screenshots of Profile - Axes - Physical and Logical. Also External devices tab. You've shown results. We need settings.
PS
Z-axis means twist?

[Pgt691]

I have the same problem with the right stick of my dual slick setup I’ve found that it needs to be unplugged and then replug then it works very annoying

[fallout9]

That's not how it's supposed to work. Please present screenshots as asked above.