Gladiator K LED

[Monkey Pants]

Hi,

First post here - hopefully in the right place

I have a new Gladiator K SCG-R and have a couple of questions regarding LEDs:

1. I understand the mode switch is no longer active on the "K" but how can I change the mode light to not be red all the time?

2. Product description says "Programmable red color LED & Programmable RGB LED". How do I manage these :

- User Guide says Global - External - LED panel (Fig 2.15) This tab is not present on my VKB Device Config (v0.91.30)



Thanks

MP

[fallout9]

In order to get access to LEDs you'll have to add this line: User=Developer under [User] section in the file called zconfig.ini, which is in the same folder where the VKBDevCfg is stored. After this you could program your LEDs: on the Gladiator base the LED is number 0; the LEDs on Kosmosima grip are numbers 10 and 11. For more about programming LEDs: manual.

[Monkey Pants]

All sorted: thanks for the quick reply

MP

[TheGeek]

What number would be the green LED on the Gladiator base?

[fallout9]

The answer is 2 posts higher: 0.

[TheGeek]

My apologies for not being more specific.

There are two LED's on the Gladiator base, a red LED (which is assigned ID 0) and a GREEN LED which I can't seem to figure out the ID for. This is the LED I'm looking for the ID number for, if it is able to be controlled.

[Ron61]

This one also has the number 0, only in a different color. Consider that you have one two-color led.

[TheGeek]

Ah that explains it.
So if I set ID 0 to a red color, the RED LED should light, and set it to a green color it should light up?
Could you clarify a little bit?
How would you:
1. Turn the RED LED ON
2. Turn the GREEN LED ON
3. Turn BOTH LED's on at the same time (if possible)

Thanks again for the help!

[Ron61]

With these settings, the following results will be obtained:
1 line - when turned on, the upper (first led) will be constantly on - red.
2nd line - when the logical button 5 (D1) is pressed, the second led will light up - green, but the first one does not go out.
3 line - when you press the Shift1 button, the bottom (green) will blink quickly and the first will go out.

[fromega01]

OK and for external led, how much connector are in the gladiator nxt to add led please?