Question about axis calibration
Moderator: AdminGroup
Question about axis calibration
When I watch a Youtube video showing the calibration of a Gunfighter Pro X & Y axis, the Y axis was perfectly still while the X axis moved & vice versa. When I watch my calibration with the "Test" function while running VKBconfig.,I see lots of movement in the axis that I'm not trying to move, instead of only seeing one axis move. Why would this be & is there anything to do about it?
- fallout9
- Posts: 5186
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Question about axis calibration
Maybe in that video the base had the hard centering cams and strong springs and you're on soft centering cams and soft springs? Doesn't matter how many axes are moving at the same time, you just to make sure you're moving each axis on its whole range back and forth, brake lever and second trigger included.
Re: Question about axis calibration
Thanks for the response! I'm just wondering though , if the movement in the axis I'm not trying to move(especially around the center) is having an impact on very delicate procedures like air to air refueling. I have combined springs to add up to a total strength of 80.
- fallout9
- Posts: 5186
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Question about axis calibration
If you are concerned about axes bleeding into each other then adding springs is not the final solution; changing to hard centering cams (#30) helps more. If you want to stick with the soft centering cams (#10) then nothing else than training more with the device would help
Re: Question about axis calibration
Thanks again! I am thinking that that the axes are possibly bleeding into each other.I will give the hard centering cams a try.
Re: Question about axis calibration
Uh Oh!! I just switched cams so I have the #30 cams on now. I tried to be very careful doing this & I thought everything went well. I have a green light on the black box & the stick feels good, BUT the pitch & roll axes aren't recognized at all in game. The buttons are all recognized, but not the pitch & roll. I looked at the connectors & they look OK. Any idea what went wrong?
- fallout9
- Posts: 5186
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Question about axis calibration
Usually, if you're replacing the springs or the cams or both you have to recalibrate.
Re: Question about axis calibration
Yes, that's all it was, just needed to calibrate! Your help is much appreciated !
Return to “Manuals and Howtos”
Who is online
Users browsing this forum: No registered users and 54 guests