I'm having an issue attempting to get the left analog stick on the MCG Pro to function as an axis input. After following this thread;
viewtopic.php?f=25&t=3184
and this one;
viewtopic.php?f=25&t=3044
I'm ALMOST there. I have both ministicks reading on the Test-Axis page on the Device Config utility. The problem now is that the horizontal axis on the Gate-Cont ministick reads a value of zero (instead of 32767) when the stick is physically centered after an auto calibration. Moving the stick fully right will output 65535, but moving left of center does nothing. I CAN manually adjust the Bias value and play with KdHi and KdLo to get close to the behavior I want, but by doing this manually I either have unused physical travel in the stick, or the physical center does not get close to 32767: that is, the axis value maxes out before the hard stop, or the physically centered value is not quite centered.
My question is if I'm doing anything wrong or if there is an obvious way to get this axis to automatically calibrate like the top ministick, which is behaving exactly as I want it to.
1 - Device model and version - Gladiator Pro Mk II with MCG Pro
2 - Controller Firmware version - Gladiator_MCG_Pro_v1_94_B
3 - Number and type of springs used - as shipped, not that it matters
4 - Тype of cams used - #10 not that it matters
5 - If VKB original software is used, please always mention its version - VKB Dev Config v0.87.05 and Joy Tester version ?????
Working on the screenshots now, I'll edit this post with them shortly.
[Solved] Gate-Cont Ministick Horizontal Axis Range
Moderator: AdminGroup
- rrohde
- Posts: 618
- Joined: Thu Oct 08, 2015 9:28
- Location: USA
- Has thanked: 681 times
- Been thanked: 242 times
Re: Gate-Cont Ministick Horizontal Axis Range
Pinging UIV, Alex, VictorUs and AeroGator to provide some support here.
Thanks.
Thanks.
VKB North America
https://VKBcontrollers.com
https://VKBcontrollers.com
Re: Gate-Cont Ministick Horizontal Axis Range
You have unchecked CN (Axis with center) for Axis #6. Logical axes tab. Try to check.
Руководство пользователя по контроллерам VKB (VKB controllers User Guide) Ru&En
https://disk.yandex.ru/d/LlqiYtIrIetBOQ
https://disk.yandex.ru/d/LlqiYtIrIetBOQ
Re: Gate-Cont Ministick Horizontal Axis Range
It's actually on axis 8, but checking CN on that axis fixed it.
I knew the problem had to be user error. Thank you very much!
I knew the problem had to be user error. Thank you very much!
Who is online
Users browsing this forum: No registered users and 13 guests