So I managed to fix 1 problem although it shouldn't be a problem.
Somehow my warthog throttle is interfering with the stick. Specifically 1 button #23 which on mine is the front 5 way push IN button. I had my SCB's mapped to that.
Now in game while in combat I use the thrusters (index finger 4 way hat) A LOT and the SCB's were firing while I was using the thrusters randomly. I remapped then SCB's to the push forward button on the same 5 way and is good now.
Still having the button 14(thumb 5 way UP) activating intermittently while pressing/holding button 4 (RED). See Jake's pic above. Same buttons but different numbers.
Having MCG Pro Issues, random intermittent button presses
Moderator: AdminGroup
Re: Having MCG Pro Issues, random intermittent button presses
SpaceJake wrote:Ha!
Qyv10 wrote:BUT
Guys I sent both of you PMs and re-sent them this morning. Please check.
We're asking you to run some tests (link to testing soft included) and reply to me via PM.
Thanks!
Best Regards,
AeroGator
AeroGator
Re: Having MCG Pro Issues, random intermittent button presses
Try to check the new firmware http://ftp.vkb-sim.pro/Firmware/BlackBo ... 1_91_F.rar
Re: Having MCG Pro Issues, random intermittent button presses
UIV, I sent you a PM but not sure you got it as it's not showing in my PM folder.
If not let me know and I'll resend. Thx
If not let me know and I'll resend. Thx
Re: Having MCG Pro Issues, random intermittent button presses
Ok. I resent. It's in my outbox so hopefully it went this time.
Re: Having MCG Pro Issues, random intermittent button presses
I sent 4 to aerogator which are from 1.91E. F shows the same but much better.
Re: Having MCG Pro Issues, random intermittent button presses
Please, try to make the screenshots from 1.91.F
Have a difference in FW. Only buttons log from latest firmware can help us to solve the problem.
Thank you.
Have a difference in FW. Only buttons log from latest firmware can help us to solve the problem.
Thank you.
Re: Having MCG Pro Issues, random intermittent button presses
I am having the Red button (4) -> button 14 phantom intermittent button press issue as well on my MCG Pro (3 pin). I've tried firmware 1.92.1 which does not fix the issue. Is there a known fix for this?
-
- Posts: 2
- Joined: Wed May 09, 2018 17:40
Re: Having MCG Pro Issues, random intermittent button presses
i had issues with random break lever activations when moving the stick. after i reseated the stick on the base this issue was gone. i think i didnt tighten the stick enough and the pins on the stick were losing connection when moving it.
i havent had this problem again since
i havent had this problem again since
Re: Having MCG Pro Issues, random intermittent button presses
I have a similar issue too for my MCG Pro + stick extension. Here are some of my issues:
1. When I move the stick, sometimes button #18 (the push in button of the 4 way switch below the POV ministick) and button # 23 (the push in button of the 4 way switch at the front right of the grip) will activate intermittently
2. It is more rare to happen but button #9 (the push in button of the 4 way switch on the thumb position) and pov 1 (I believe down position) will also activate intermittently
3. On releasing the button #4 (the red button), button #14 (the up position of the 4 way switch below the POV ministick) sometimes will activate
4. In a rare occasion, even without moving the joystick, by just leaving the stick in close to centre position, #18, #23 and #9 button will just continue to activate intermittently
I have followed the steps from https://vkbcontrollers.com/?p=15551 to flash, reset and calibrate the stick, I have also tighten up all the screws but the problems above still exist.
Gunfighter 3-pin Rev.A base
MCG Pro + stick extension
#50 spring
VKB Device Config v0.87.05
Firmware v1.92.1
1. When I move the stick, sometimes button #18 (the push in button of the 4 way switch below the POV ministick) and button # 23 (the push in button of the 4 way switch at the front right of the grip) will activate intermittently
2. It is more rare to happen but button #9 (the push in button of the 4 way switch on the thumb position) and pov 1 (I believe down position) will also activate intermittently
3. On releasing the button #4 (the red button), button #14 (the up position of the 4 way switch below the POV ministick) sometimes will activate
4. In a rare occasion, even without moving the joystick, by just leaving the stick in close to centre position, #18, #23 and #9 button will just continue to activate intermittently
I have followed the steps from https://vkbcontrollers.com/?p=15551 to flash, reset and calibrate the stick, I have also tighten up all the screws but the problems above still exist.
Gunfighter 3-pin Rev.A base
MCG Pro + stick extension
#50 spring
VKB Device Config v0.87.05
Firmware v1.92.1
Who is online
Users browsing this forum: Bing [Bot], Google [Bot] and 100 guests