VKB-SIM

Recently received my Gunfighter MK2 TableTop. It's a great stick but unfortunately it arrived without baseplate screws...

Have raised a support request but didn't get a reply (at least not yet), thinking as it's such a small piece I can just order replacements online.


Can anyone advise what screws to order? They are also the same fit as the ones on the top-place, for the stick itself (uses the supplied Allen key).

Where and when addressed? Show a photo of the place where there are no screws.

On the base plate no screws were included. Screen attached.

Worth seeing in the packages with cams and springs, perhaps they are there.

I of course checked all packaging (have fully set up the stick and tested it works with change of springs now too) - To make it work temporarily i have taken 2 screws from the top of the stick to use underneath but that's not ideal.

Just want to know what type of screw this is so I can buy online (or better yet VKB can send me the ones that were supposed to be included originally)!

М4х20 DIN 7991,it is possible and others under the "cross."

Thanks!

FYI, for anyone reading. VKB have emailed me and are going to send some out. Was going to just order them myself but that's great so thanks ^_^

Just as an FYI mine were in the bag with the spare springs and alternate cams. There was a lot in there so they were a little tough to see and to get to without dumping the bag everywhere.

@rtrski - Fair enough!

I'm 100% they were not in there in that case, went through everything including cams and springs bag in order to configure the stick (i changed the springs). There was another small bag with plastic spares but not in there either. Checked every piece of foam in the box twice, etc.

Anyway a very minor issue as they were probably overlooked but are commonly available (now i searched the part number as advised by Ron61) and VKB are even resolving this by sending them out!