Side throttle for the Gladiator NXT?
Posted: Mon Oct 27, 2025 12:34
Hello,
I’m looking to add a throttle joystick to the side of my VKB Gladiator, similar to the Virpil Aeromax ( https://virpil-controls.us.com/cdt-aero ... odule.html ). I’m considering designing and 3D printing one, but I’m unsure of what’s needed for the Gladiator to properly read the new axis. Could you provide some information about this? Alternatively, would it be possible to purchase the “GNX USB Controller (HID-Main)” with the "GNX Module-to-Module Interface Cable (Type-C to JST2.0-4)" to make this work?
Furthermore, if you had any CAD files for the “coupler,” that would greatly assist me in designing the throttle casing and minimize the need for extensive trial-and-error fitting.
The files will be available for free after the project is complete.
Thank you very much!
I’m looking to add a throttle joystick to the side of my VKB Gladiator, similar to the Virpil Aeromax ( https://virpil-controls.us.com/cdt-aero ... odule.html ). I’m considering designing and 3D printing one, but I’m unsure of what’s needed for the Gladiator to properly read the new axis. Could you provide some information about this? Alternatively, would it be possible to purchase the “GNX USB Controller (HID-Main)” with the "GNX Module-to-Module Interface Cable (Type-C to JST2.0-4)" to make this work?
Furthermore, if you had any CAD files for the “coupler,” that would greatly assist me in designing the throttle casing and minimize the need for extensive trial-and-error fitting.
The files will be available for free after the project is complete.
Thank you very much!