I've been thinking about this some more and was wondering, would it be possible to connect the STEM to a GNX THQ-V, install a GNX USB controller into the GNX THQ-V and then plug that into my PC?
Because, I'm guessing, installing the USB controller into the GNX THQ-V takes away the Type-C to Type-C connection, would I have to connect the STEM to the GNX THQ-V using a Type-C to JST2.0-4 cable? Is that possible and would it work? Thanks.
STECS Modules (ATEM and STEM) Can Be Used On Their Own?
Moderator: AdminGroup
- fallout9
- Posts: 5211
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1224 times
Re: STECS Modules (ATEM and STEM) Can Be Used On Their Own?
Yup, the USB to JST cable would help with that.
Re: STECS Modules (ATEM and STEM) Can Be Used On Their Own?
That's great!
And one more question.. To allow me flexibility in positioning the STEM I could extend the length of the USB to JST cable with a Type-C to Type-C module cable connected to it using a USB Type-C coupler?
Thanks.
And one more question.. To allow me flexibility in positioning the STEM I could extend the length of the USB to JST cable with a Type-C to Type-C module cable connected to it using a USB Type-C coupler?
Thanks.
Re: STECS Modules (ATEM and STEM) Can Be Used On Their Own?
AlpineGTA wrote:I could extend the length of the USB to JST cable with a Type-C to Type-C module cable connected to it using a USB Type-C coupler?
Thanks.
Working great for me. Just make sure it couples all the pins (the ones marked USB3 should do that).
Re: STECS Modules (ATEM and STEM) Can Be Used On Their Own?
Thanks. I've ordered a USB 3 one, ready for when my VKB parts arrive.
Re: STECS Modules (ATEM and STEM) Can Be Used On Their Own?
So I have the USB controller inserted into my GNX THQ-V and that's plugged into the PC, configured and working fine. However, I have a JST cable from the GNX THQ-V plugged into STEM module but I can't get the Device Config to recognise it and get it working. I've tried hitting the Default button in Device Config on the the GNX but I can't get it to see the STEM.
Re: STECS Modules (ATEM and STEM) Can Be Used On Their Own?
Device Config at the top says: VKB Device Config v0.92.88 ( NJoy32 firmware v2.16.0)
and the THG module says: VKBSim NXT THQ XT2 v2.176
I'm not sure if that's the latest, I'll go and check. Thanks.
and the THG module says: VKBSim NXT THQ XT2 v2.176
I'm not sure if that's the latest, I'll go and check. Thanks.
Re: STECS Modules (ATEM and STEM) Can Be Used On Their Own?
It was my mistake. When I disconnected the STEM from my STECS I'd forgotten to reconnect the cable inside to the USB bus. I have it working now. Thanks.
Return to “General discussions”
Who is online
Users browsing this forum: No registered users and 7 guests