Hi there,
I am planning to buy an Evo with OTA (left). However, I have an NXT THQ with FSM GA attached to the left of my Gladiator. Wouldn't that cause problems with the right axis of the THQ with the angled adapter? Are there any plans for an adapter for the GNX Modules to put them a little further to the left? I could of course disconnect the THQ/FSM GA from the GNX. But then I would need an extra mount.
Best regards,
InvaderZim
EVO OTA and THQ/SEM, blocked axis?
Moderator: AdminGroup
-
- Posts: 15
- Joined: Thu May 13, 2021 16:16
- Has thanked: 1 time
- fallout9
- Posts: 5189
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: EVO OTA and THQ/SEM, blocked axis?
Connecting a SEM or THQ module on the left side of the joystick while using an OTA is not recommended. You could move the module(s) on the right side of the joystick or upgrade them with GNX-HID controller and use them as an independent unit.
-
- Posts: 15
- Joined: Thu May 13, 2021 16:16
- Has thanked: 1 time
Re: EVO OTA and THQ/SEM, blocked axis?
Thanks!
I already use a GNX-HID for the left modules. I had only misused the gladiator as a holder.
I also dug out an old mount from an old throttle so all should be set now. Can't wait to get the Evo
Best regards,
InvaderZim
I already use a GNX-HID for the left modules. I had only misused the gladiator as a holder.
I also dug out an old mount from an old throttle so all should be set now. Can't wait to get the Evo
Best regards,
InvaderZim
Return to “General discussions”
Who is online
Users browsing this forum: No registered users and 78 guests