VKB-SIM

Hello,
I installed my SEM onto my Gladiator NXT WWII exactly as shown in the youtube tutorial. However it dosen't seem to work, there are no lights blinking when pressing b1 b2 b3 and plugging it in and the buttons do not work. The cable meant to connect both devices has a 4 end and 3 end connector. The slot, which is meant for the cable, in the stick has 4 pins instead of 3. There was a second cable delivered with two 4 end connectors, is it the wrong cable I am using ?

Post a screenshot of VKBDevCfg with the device connected.

The issue is somewhat solved. I used the other cable (not the one from the tutorial) and now it works all lights are on, the buttons work and VKBDefCfg recognizes all Buttons/Axes. I don't know if the slot got changed from 3 pin to 4 pin but it didn't work with this tutorial https://www.youtube.com/watch?v=LBhCx1jQ6mE the other cable solved the issue.

Could you please post a picture with the modules bottoms up so we could see the connections?

Is there an E-Mail I can send it to ? This forum dosen't allow me to upload files with a Error message "HTTP Error"

After you click the Post Reply button just scroll down and you'll see the Attachment tab, which will allow you to navigate to your picture and load it up.

yes... exactly this doesn't work for me, tried two different browsers and 3mb shouldn't be too big either.

I think there's a 2mb limit.

Just plug 4pin to SEM (TRQ, or any module) and 3pin to NXT EVO. The red line should be at the edge of the EXT socket. Now both will work without any problem. Even plugging 4 to 4pin cable to both device works well.
VKB has missed to notify this change of EVO and not so little users are confused.