VKB-SIM

Made these for 3D printing .. still WIP .. tested with KG12 and MCG .. for now

That's a nice idea congrats! But please check 3 times to make sure the knob in the center doesn't keep the little pins in the base of the grip in tension or push/pull them to the sides.

I have checked that the center pin does not push the pins and I have changed the design og the centerpin with a cutout for the clamp. The previous design was just to tight.
Added F-14 and SCG.
I plan to make versions with allankey holder on the holder it self.
Will also add blinds to fill the not used link slots.

Find the latest files here https://www.thingiverse.com/thing:4406980

I have just received the F-14 grip .. and it is different from the KG12 and MCG ... and a new design is on the way.

Can someone confirm that the SCG has same dimensions as KG12/MCG as to the tablestand?

Thank you, Zappovitz, for this clever design. I've utilized your F-14 and standard stand.

I have all the VKB grips---so I can let you know the SCG/Kosmosima grip is very similar to the F-14 with its twist functionality---so the support design for the F-14 works well, rather than the standard (I tested) which is incorporated into the SCG-specific stand.

Again, thanks for sharing the work you've done designing these.