Tablestand for grips.
Moderator: AdminGroup
Tablestand for grips.
Made these for 3D printing .. still WIP .. tested with KG12 and MCG .. for now
- Attachments
-
- VKB TableStand.zip
- All files for now
- (642.94 KiB) Downloaded 152 times
- fallout9
- Posts: 5182
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Tablestand for grips.
That's a nice idea congrats! But please check 3 times to make sure the knob in the center doesn't keep the little pins in the base of the grip in tension or push/pull them to the sides.
Re: Tablestand for grips.
I have checked that the center pin does not push the pins and I have changed the design og the centerpin with a cutout for the clamp. The previous design was just to tight.
Added F-14 and SCG.
I plan to make versions with allankey holder on the holder it self.
Will also add blinds to fill the not used link slots.
Added F-14 and SCG.
I plan to make versions with allankey holder on the holder it self.
Will also add blinds to fill the not used link slots.
- Attachments
-
- VKB TableStand.zip
- (537.73 KiB) Downloaded 150 times
Re: Tablestand for grips.
I have just received the F-14 grip .. and it is different from the KG12 and MCG ... and a new design is on the way.
Can someone confirm that the SCG has same dimensions as KG12/MCG as to the tablestand?
Can someone confirm that the SCG has same dimensions as KG12/MCG as to the tablestand?
Re: Tablestand for grips.
Thank you, Zappovitz, for this clever design. I've utilized your F-14 and standard stand.
I have all the VKB grips---so I can let you know the SCG/Kosmosima grip is very similar to the F-14 with its twist functionality---so the support design for the F-14 works well, rather than the standard (I tested) which is incorporated into the SCG-specific stand.
Again, thanks for sharing the work you've done designing these.
I have all the VKB grips---so I can let you know the SCG/Kosmosima grip is very similar to the F-14 with its twist functionality---so the support design for the F-14 works well, rather than the standard (I tested) which is incorporated into the SCG-specific stand.
Again, thanks for sharing the work you've done designing these.
Return to “General discussions”
Who is online
Users browsing this forum: No registered users and 35 guests