Hello,
Just received my new GF3 + MGC PRO. Documentation is scarse ( ).
I suppose that what applies to GF MKII applies to GF MKII ?
Some question :
- how do you remove dust cover ? I suppose I just have to unscrew the screws under the dust cover (I have to raise the cover ?).
-what is the use of the switch on the black box ?
- if there are some, are there some special settings for GFIII ?
- what is the use of the small platic bar with the two holes for the two black small screws ?
Thanks for your help.
Waiting for a correct documentation
Regards
GFIII some question
Moderator: AdminGroup
- fallout9
- Posts: 5189
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: GFIII some question
I suppose that what applies to GF MKII applies to GF MKII ?
Mostly yes
- how do you remove dust cover ? I suppose I just have to unscrew the screws under the dust cover (I have to raise the cover ?).
There are 4 screws, 2 exposed at the back and 2 under the boot at the front. Don't forget to disconnect the cable.
-what is the use of the switch on the black box ?
Putting the Black Box in bootloader mode.
- if there are some, are there some special settings for GFIII ?
Similar to GFII.
- what is the use of the small platic bar with the two holes for the two black small screws ?
That gets screwed in the back of the Black Box and acts as a cable guide if needed.
- fallout9
- Posts: 5189
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: GFIII some question
It would be a very rare and unfortunate case when you'll get to the point of needing to activate that button. Just be careful to flash the right firmware and load the correct profile and you won't ever need to get there.
Return to “General discussions”
Who is online
Users browsing this forum: No registered users and 86 guests