Page 1 of 1
Mk III Springs and Cams
Posted: Sat Dec 14, 2019 5:58
by Catseye
Hi,
What is different about the new Mk III springs compared to the old Mk II springs?
Do the cams in the new Mk III accept 2 springs each?
Thanks for the info.
Cats . . .
Re: Mk III Springs and Cams
Posted: Sat Dec 14, 2019 10:29
by fallout9
Looks like the new springs are not going all around the pins like the original ones, so it should be easier to put them on/ take them out. Not sure about their hardness. But I know that 2 springs per axis is still possible with the new cams.
Re: Mk III Springs and Cams
Posted: Sat Dec 14, 2019 13:34
by Glorioso
fallout9 wrote:Looks like
sausage stuffers are getting a lot better and the new springs are not going all around the pins like the original ones, so it should be easier to put them on/ take them out. Not sure about their hardness. But I know that 2 springs per axis is still possible with the new cams.
Pulling them out too often would wear them out, no?
Re: Mk III Springs and Cams
Posted: Sat Dec 14, 2019 21:05
by fallout9
I don't think someone would have enough energy to significantly wear the springs by taking them out
And even so, they come with lots of replacements...
Re: Mk III Springs and Cams
Posted: Tue Dec 17, 2019 2:24
by ARX-7
To wear them out you'd need to stretch them past the elastic point which will be fairly obvious.
Or get them hit enough which is also pretty silly