Gladiator with MCG PRO
Moderator: AdminGroup
Gladiator with MCG PRO
I have a gladiator base and I installed a MCG PRO on top of it using the gladiator lite kit. Once I was done I plugged it in and the red light flashes on the gladiator base non stop. I went through the process of using the VKB config and firmware 1.94 from VKB. The x and y axis and slider are recognized in vkb config but the buttons on the stick don't work at all. I ran calibration on the stick and when I dot that the green light flashes on the vkb base and when I end calibration the green light goes out and the red light starts flashing rapidly again. Can someone please help me out with this also in the VKB config when under tools test and external devices it shows the MCG pro with a red x next to it and the bar is red from top to bottom. can someone please help. thanks
Return to “General discussions”
Who is online
Users browsing this forum: No registered users and 28 guests