Kosmo pinky mod question

Moderator: AdminGroup

Cassiop
Posts: 13
Joined: Sun Sep 23, 2018 18:54
Been thanked: 4 times

Re: Kosmo pinky mod question

Postby Cassiop » Wed Jun 19, 2019 18:49

Ok boys, it was time for a MK2. dont be fooled by this amazing design. It even rotate ! thus it was not something it was designed to do. but you know, sometime things happen.
It is a simpler design, it goes through the hole (without forcing it Too much), and after few tweak it push the button well enough. i can grab it with whatever finger i like.
once again, the design is too bad to be shared but you get the idea ! i'll keep that for a while and see how it do !

Image

Image

MelkorsGreatestHits
Posts: 15
Joined: Wed Jun 12, 2019 0:09
Has thanked: 1 time
Been thanked: 12 times

Re: Kosmo pinky mod question

Postby MelkorsGreatestHits » Thu Jun 20, 2019 14:52

Yikes! That is...something...

Did you see the picture of the user who just put a little rubber dot on their pinky button?

User avatar
AeroGator
Posts: 827
Joined: Wed May 31, 2017 7:40
Has thanked: 378 times
Been thanked: 479 times

Re: Kosmo pinky mod question

Postby AeroGator » Sat Jun 22, 2019 5:32

In fact... if not hte color it would even look good!
Best Regards,
AeroGator

Cassiop
Posts: 13
Joined: Sun Sep 23, 2018 18:54
Been thanked: 4 times

Re: Kosmo pinky mod question

Postby Cassiop » Sat Jun 22, 2019 14:57

MelkorsGreatestHits wrote:Did you see the picture of the user who just put a little rubber dot on their pinky button?


yes but i didn't though of this. Smart idea ! But i wanted something bigger anyway. i liked the idea of a rotating lever that you can pull with different fingers. i'll have to buy a smaller nose cone for my 3D printer and run some test !

AeroGator wrote:In fact... if not hte color it would even look good!

i agree. but it was this or some kind of translucent yellow. it would have been worst =P

MelkorsGreatestHits
Posts: 15
Joined: Wed Jun 12, 2019 0:09
Has thanked: 1 time
Been thanked: 12 times

Re: Kosmo pinky mod question

Postby MelkorsGreatestHits » Sat Jun 22, 2019 15:04

what if you sand it smooth and then paint it black? or red!

what's the diameter of the hole there? now you've got me thinking about alternatives :-p


Return to “General discussions”

Who is online

Users browsing this forum: No registered users and 40 guests