Hi,
I was converting a Warthog grip from the 3pin Rev.A adapter to the 5pin adapter for a friend, and I noticed the PCB board differed from the 3pin board.
Not only is the 5pin board bigger, it also has extra mini-molex connectors underneath the shrinkwrap. My question is, what are these molex connectors for?
what are the extra connectors for on the Warthog 5pin adapter?
Moderator: AdminGroup
Re: what are the extra connectors for on the Warthog 5pin adapter?
Right is the v1 board, left is the v2.
Functionally there is no difference whatsoever.
Molex connector of the v1 board is not for anything; we thought we'd use it for extensions but later we thought we'd do it in a different way, and in v2 this connector was simply cancelled altogether.
Functionally there is no difference whatsoever.
Molex connector of the v1 board is not for anything; we thought we'd use it for extensions but later we thought we'd do it in a different way, and in v2 this connector was simply cancelled altogether.
Best Regards,
AeroGator
AeroGator
Return to “General discussions”
Who is online
Users browsing this forum: No registered users and 26 guests