Where/When I can I buy a Warthog adapter for the Gladiator Pro?

[rrohde]

I installed my adapter circuit board underneath the main Circuit Board in the grip. Not sure if that was right but did not see any other place to locate it.

That's the correct way! Did you not get that PDF that I sent out to all who ordered one of those VKB TM Warthog adapters for Glad Pro?

[kverdon]

No I did not but thanks for confirming I got it right.

Looking forward to giving it a whirl tomorrow.

[rrohde]

Better late than never.

[kverdon]

Thanks. So a question for you or anyone else who has installed the adapter, for the x-axis, did you stick with the stock 10 Cam with the heavier Warthog adapter springs or did you swap or the x cam for the 30 cam?

Go it back together and it is working in test mode using the config you sent.

[rrohde]

Thanks. So a question for you or anyone else who has installed the adapter, for the x-axis, did you stick with the stock 10 Cam with the heavier Warthog adapter springs or did you swap or the x cam for the 30 cam?

Go it back together and it is working in test mode using the config you sent.

I used the 10 Cam before I put the TM Warthog grip on, and I still use for the roll axis, which I switched the pitch axis over to the W cam. Works well for me.

[kverdon]

Ok, thanks, that is what I did. One piece of feedback I would have would be to either include the friction lock pieces with the adapter or make them available for purchase after. It would make swapping grips easier.

[rrohde]

That sounds like a good idea. From what I understand, VKB already have resigned this for the Gunfighter, so I am curious how the final product will compare.