Black mamba mk III firmware
Posted: Wed Apr 27, 2016 19:47
So i just got my black mamba mk 3 and I was eager to set it up and start using it. Everything worked great, I had three green LED that would flick on and off with the GEAR switch. I had an engine warning light to play with. Everything seemed to work well when i tested buttons with control panel>Game Controllers>Properties. Then i went to support page and downloaded the configuration tool. The configuration tool is telling me that my firmware is out of date and i've lost my LEDS. The stick still seems to work for a while but while writing this the stick seems to have switched off. I have downloaded bootloader but all i can get from it is that my stick is disconnected.
It seems that running bootloader is what is switching the stick off. Once i have run bootloader and it crashes the stick if i run it again and hit the reset button the stick comes back on but still no LEDs apart from the blue one. VKB device config is still telling me the firm ware is out of date ( VKB Fat Mamba V.1.43F PRO )
From the support page V1.43F seems to be the most up to date if it isnt where can i get the right one?
Otherwise seems like a good stick
just realized i put this on the wrong board
It seems that running bootloader is what is switching the stick off. Once i have run bootloader and it crashes the stick if i run it again and hit the reset button the stick comes back on but still no LEDs apart from the blue one. VKB device config is still telling me the firm ware is out of date ( VKB Fat Mamba V.1.43F PRO )
From the support page V1.43F seems to be the most up to date if it isnt where can i get the right one?
Otherwise seems like a good stick
just realized i put this on the wrong board