VKB-SIM

Ok boys, it was time for a MK2. dont be fooled by this amazing design. It even rotate ! thus it was not something it was designed to do. but you know, sometime things happen.
It is a simpler design, it goes through the hole (without forcing it Too much), and after few tweak it push the button well enough. i can grab it with whatever finger i like.
once again, the design is too bad to be shared but you get the idea ! i'll keep that for a while and see how it do !

Yikes! That is...something...

Did you see the picture of the user who just put a little rubber dot on their pinky button?

In fact... if not hte color it would even look good!

MelkorsGreatestHits wrote:Did you see the picture of the user who just put a little rubber dot on their pinky button?

yes but i didn't though of this. Smart idea ! But i wanted something bigger anyway. i liked the idea of a rotating lever that you can pull with different fingers. i'll have to buy a smaller nose cone for my 3D printer and run some test !

AeroGator wrote:In fact... if not hte color it would even look good!

i agree. but it was this or some kind of translucent yellow. it would have been worst =P

what if you sand it smooth and then paint it black? or red!

what's the diameter of the hole there? now you've got me thinking about alternatives :-p