question regarding customizing setup

[Pierdzimir]

Hi there,
I'm looking to update my current setup.
I need help in ordering the right parts. Search function in the shop is a bit confusing, I have difficulty searching for different extensions.
i'm interested in getting:
1) Gunfighter IV ‘Modern Combat Edition’ Ultimate
2) STECS Throttle System (probably "Standard") (does the WW2 combo has 1 throttle or 2? It looks like it's one, that can be split into 2)
3) SEM-V module
4) GNX FSM-GA (Front Switchboard Module – General Aviation)
5) T-Rudder Pedals Mk.V

I plan to have joysick and gnx on the right hand side, throttle and sem v on the left.
Does VKB sell other mounts/parts i should add to this to make it work together?
I'd prefer to mount this to my existing table, instead of getting a whole new chair with mounts and sheet.
Thank you
Konrad

[fallout9]

You can have either FSM or SEM attached to the STECS by the MFH, like shown in this video. For the remaining one (either FSM or SEM) you'll have to find a way to attach it to your mounts/desk, as they can't function unsecured, they will slide around. Also, if you need to get one of them acting like an independent unit you'll need a GNX HID Controller too.
Just a heads up - if you'll attach the MFH to the STECS that will only be viable for desktop use, as the unit will be simply too long for mounts.

[Pierdzimir]

Thank you for the reply. I've whitelisted "my build":
1) Gunfighter IV will be mounted to UCM-S for Gunfighter (can i mount GNX FSM-GA to the UCM mount above joystick?)
2) STECS Throttle System - Standard will be mounted to UCM-S for STECS (can i mount GNX SEM above the STECS?)
I looks like i can skip GNX MFH and mount both GNX modules directly to the UCMs, question is do i need any additional adapter plates between GNX modules and UCMs?
Thank you!

[fallout9]

Yes to both. You can mount both the FSM and SEM (make sure you chose the Vertical SEM) on the UCM (there is a perforated plate included, which will allow attaching the modules).
You can skip the MFH, but you will need 1 GNX HID Controller for the module which will get mounted over the Gunfighter. The module which get mounted over the STECS can get plugged into the STECS with a USB C to USB C cable, which is included.
This way, you'll end up with 3 USB devices: the Gunfighter, the independent module on the Gunfighter side and the STECS + the second module.

[Pierdzimir]

Thank you for your help. You saved my a lot of headache and incorrect order (i wouId be missing that usb port hub) just made an order: 64633
Best Regards

[fallout9]

Good to hear! One more thing - please join our incredible kind and helpful Discord server with lots of good tips and related chatter.