I had an idea about the pinky button of the Kosmo. I didn't received my unit yet but i'm pretty sure i'll be struggling with the pinky because of the small hands i have. (i struggled with pinky buttons on the Warthog and the X56 so....)
there is what i planned (dimensions are guessed, around ~8mm for the button's diameter, and i still have to figure out how to avoid the outershell to move but... there is the idea.)
https://imgur.com/a/YcmvIy9
![Image](https://i.imgur.com/nKZhFjP.png)
![Image](https://i.imgur.com/Me05sYT.png)
In the meantime, reddit user /u/jaseworthing kindfully provided me a pic of the PCB button holder inside the grip to have an idea of what i should expect inside.
https://imgur.com/a/MNHW0BO
![Image](https://i.imgur.com/yM4IIH1.jpg)
is seems that this little piece of PCB, holding the button, is glued to the support as Jaseworthing wasn't able to pull it off. So, I either have to find a solvant to disolve the glue, as Jaseworthing suggested to me (Maybe VKB know this answer ?), or i have to think to something else.
I may also kindly ask VKB to not glue this part in my order but i dont think it will fit well in their already busy industrial process ^^
Feedback on the idea are welcome, tell me what you think ! Also, if everything is fine i would gladly share this with the community ! But since it will be my first 3D printed design i'm pretty sure there will be problems.
thanks !
reddit thread
https://www.reddit.com/r/hotas/comments ... ma_during/