Create two virtual axes with gradual increase/decrease using buttons
Posted: Sat May 03, 2025 16:36
Hi everyone,
I’m trying to create two virtual axes on my VKB Gladiator nxt evo (Axis ID 9 and 10) to control left and right wheel brakes.
Here’s the behavior I want for each axis:
- When I press a button (e.g. Button 49 for Axis 9, Button 50 for Axis 10), the corresponding axis should gradually increase (e.g. up to 255).
- When I release the button, the axis should gradually decrease back to 0.
- Ideally, the increase rate is slightly slower than the decrease, to simulate the feel of a brake pedal that returns on its own.
I’m using VKB Device Config with Njoy32 firmware v2.19, and I’d like to know how to configure this behavior step-by-step.
Thanks in advance for your help!
I’m trying to create two virtual axes on my VKB Gladiator nxt evo (Axis ID 9 and 10) to control left and right wheel brakes.
Here’s the behavior I want for each axis:
- When I press a button (e.g. Button 49 for Axis 9, Button 50 for Axis 10), the corresponding axis should gradually increase (e.g. up to 255).
- When I release the button, the axis should gradually decrease back to 0.
- Ideally, the increase rate is slightly slower than the decrease, to simulate the feel of a brake pedal that returns on its own.
I’m using VKB Device Config with Njoy32 firmware v2.19, and I’d like to know how to configure this behavior step-by-step.
Thanks in advance for your help!