VKB-SIM

I have three main rotaries on the STECS, ... one under my left pinky finger, one almost under my left middle finger, and one down low under my left thumb. If I try to use these in DCS to control axes, they do not respond. How can I simply turn all three rotaries into analog rotaries and control things trim on P51?

Thanks!

Watch this video.

Thank you! (Been a while since I dug into DevCfg.)

I will also put that for guys new to STECS, this video (at the 1:27 mark) is very helpful for turning your encoders to analog axes:

https://www.youtube.com/watch?v=GB-pf6dEICM