Configure LEDs to toggle on button

[Wild_Robbie]

I've tried searching for an answer with no luck. I have an EVO omni throttle and want to modify the LED (10) to toggle by starting on no event, then change color when I push a logical button (4) until I push that button again, at which point it goes back to no event. I found a few people mentioning P-alternate function to do this, but it doesn't work the way I think it should. I have no problems getting the LED to change while holding a shift button or using an alternate switch button. Anyone have an idea how to do this?

[Victorus]

Try to do the following. Open Buttons - Physical. Check Poll. Find PHYSICAL line number that causes LOGICAL #4 to flash. Enter this number for P-alternate.

[Wild_Robbie]

Yep that did it. I’ve had a bit of trouble programming the switches and leds because I was mixing up physical and logical values. Thanks for the help.