VKB-SIM

Ive been trying to figure out how to split an axis into 2.
Gladiator NXT Pro Firmware v2.05.3
VKBDevConfig v0.091.96

Im trying to split the twist axis into 2 separate AXIS.

I tried using some of the other methods I found here but the VKBDev looked different than mine and couldnt get it to work.
Please keep in mind that Im terrible with software like this and also have no real experience using the software.

You just need to divide the standard two-polar axis 3 of the twist into two unipolar ones. The new axis will be with a reverse.
I advise you to pre-preserve your standard profile in which the axes are calibrated by Save button (write down like Default).
Then open the Profile-Axes tab and make changes according to the picture.
After that, write these changes to the controller with the button in Action-Set.

Thank you.
Now I see what I was doing wrong. I wasn't changing the I'd. Think I can get it done now.

Look here. http://forum.vkb-sim.pro/viewtopic.php?f=27&t=6489

Again Thank you.
I cant believe it was that easy and I spent awhile trying to figure it out. Honestly controller software like that has always confused me.

I have it now working.

Victorus wrote:Look here. http://forum.vkb-sim.pro/viewtopic.php?f=27&t=6489

I had tried that link before making my own thread but I got nowhere with it for some reason. It really had me confused.

Thanks for trying to help.

See this video.

I'll give it a watch.
Your first reply cleared things up for me, now I understand the axis split.

Sorry, the answer was in the wrong topic. But I don't think it will hurt here.

No problem.