VKB-SIM

Hello.

When I use the A3 HAT on an NXT Premium, It's set to POV2 directions.
What I would like to do is press down on A3 and have it change between POV3/POV2 on sequential presses.

I interpret the instructions in the manual as follows:

*Set global POV's to 3
*Set physical lines 21-24(A3 DN,UP,L,R) to the relevant A3 POV2 hat directions
*Set physical line 14 (A3 "press") to uPOV Switch. POV N = 2, N = 3, Switch by = Cyclic
*Store Settings

A3 stays as POV2 and does not switch when I press down on A3.

Can anyone assist?

1. Set 3 POVs in Global/Commonl;
2. Set the A3 buttons as POV2, then set 4 unused buttons as POV3;

3. Set the center push button of A3 hat as Shift1;

4. Assign the A3 side buttons to be Shift1 controlled and link them to the 4 buttons previously set up as POV3.

5. Press Set to save.