Gladiator Omni Throttle Adapter Installation Instructions?

[btysgtmajor]

Hi all,

I apologize if the answer to this is obvious, but I promise I googled around and searched this forum and the YouTube channel and I can't seem to find installation instructions for installing the new Omni Throttle Adapter onto a Gladiator NXT. I'm sure it's straightforward, but I'd rather not risk damaging anything given the investment.

If any one could point me in the right direction, I'd be grateful.

Thank you in advance!

- A New Gladiator NXT Owner

[fallout9]

We'll have the video guide ready tomorrow. Sorry for the wait, it's DHL's fault!

[Vhalan]

If you can't wait for the official video, you can probably figure it out from this one: https://www.youtube.com/watch?v=d2oj8M0E-yY
It's for regreasing the twist module, but it does show the steps to open the grip and remove that module. Fast forward a bit to when they're putting it back together, substitute the OTA in place! Then it just goes into the base like normal.

[btysgtmajor]

Thanks for the replies, everyone!

[btysgtmajor]

We'll have the video guide ready tomorrow. Sorry for the wait, it's DHL's fault!

Funnily enough, DHL delivered my Gladiators 6 days earlier than projected, and I'm in Canada!

[fallout9]

I'm in Canada too, in Vancouver actually and I was looking at the tracking how my parcel was simply sitting in the local warehouse without any action for days. I had to call them twice and yell to finally throw it in a truck and deliver it.

[btysgtmajor]

Hit and miss, I guess. Sorry to hear it!

[btysgtmajor]

We'll have the video guide ready tomorrow. Sorry for the wait, it's DHL's fault!

Hey is this video up yet? Checked the YouTube channel and haven't seen it yet. Or maybe I'm just not looking in the right place?

Thanks!

[fallout9]

Check you private message please.

[btysgtmajor]

One more question: There are instructions on how to calibrate the Gladiator in this forum which detail downloading a configurator program, etc. Is that process in addition to the one outlined here https://www.youtube.com/watch?v=drifi2M50Sw ? Or is the way mentioned in the video unnecessary if the configurator method is used?

[fallout9]

It's either one or the other.