so my setup uses
the Gladiator NXT, one THQ module and one FSM module
they appear 2 controllers,
current layout is
that 8 axis are used on hid1, and only the mixture axis is on hid2, 2-7 are unused on that virtual device
they seem to appear as axis 9-16 in the software, when i check En and Vs they appear in windows too
Firmware is
v2.090
im trying to setup the encoders on my gladiator nxt, to move virtual axis on device 2, axis 2 and 3(or 9 and 10 in the software i guess)
but for some reason when i go to my encoders and set them to trimmers i can only select axis 1-8
what can i do to have some virtual axis or any other way to have a longer continous button press used with the encoders(instead of pulses?)