VKB-SIM

Hi, I just got a GNX-SEM and am trying to configure the flaps as an axis. The Youtube video shows how to configure the Landing Gear as an axis by pressing a bunch of buttons, where is the documentation that shows the buttons to press to configure the Landing Gear as an axis?

You mean this?


There are also chapters on that video, you could easily navigate where you want. Though I would advise to see the whole thing, it's very short.

Thanks, I was skipping around the video, totally missed it.

No worries, lots of info in there - take your time and ask any questions you might have, that's why we're here.

So I watched this video I dont know how many times, and there is nothing about how to set the flaps switch up with the three position detent removed and the two position detent installed...

I also watched this video multiple times and cannot find how to calibrate the flaps switch with the two position detent installed. Any help would be appreciated, thanks.

Here you could find instructions on how to set up the 2 SEM axes for different detents blocks.
If you want both detents and axis, first set up the number of detents properly, then activate the axis like here.

My VKBDevCfg isnt giving me a find&autoconfig button... what do I do about that?


EDIT... I closed the program and reopend it for the 4th time, and that button appeared... Thanks Fallout9

The button disappears after getting pressed. To get it shown again you have to press the Default button. If you're using any axes on your Gladiator NXT or module(s) you'll also need to recalibrate, as the Default button resets all settings.