SEM axis configuration via buttons instructions?
Moderator: AdminGroup
SEM axis configuration via buttons instructions?
Hi, I just got a GNX-SEM and am trying to configure the flaps as an axis. The Youtube video shows how to configure the Landing Gear as an axis by pressing a bunch of buttons, where is the documentation that shows the buttons to press to configure the Landing Gear as an axis?
- fallout9
- Posts: 5160
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 207 times
- Been thanked: 1217 times
Re: SEM axis configuration via buttons instructions?
You mean this?
There are also chapters on that video, you could easily navigate where you want. Though I would advise to see the whole thing, it's very short.
There are also chapters on that video, you could easily navigate where you want. Though I would advise to see the whole thing, it's very short.
Re: SEM axis configuration via buttons instructions?
Thanks, I was skipping around the video, totally missed it.
- fallout9
- Posts: 5160
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 207 times
- Been thanked: 1217 times
Re: SEM axis configuration via buttons instructions?
No worries, lots of info in there - take your time and ask any questions you might have, that's why we're here.
-
- Posts: 5
- Joined: Fri Nov 26, 2021 9:10
Re: SEM axis configuration via buttons instructions?
So I watched this video I dont know how many times, and there is nothing about how to set the flaps switch up with the three position detent removed and the two position detent installed...
-
- Posts: 5
- Joined: Fri Nov 26, 2021 9:10
Re: SEM axis configuration via buttons instructions?
I also watched this video multiple times and cannot find how to calibrate the flaps switch with the two position detent installed. Any help would be appreciated, thanks.
- fallout9
- Posts: 5160
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 207 times
- Been thanked: 1217 times
Re: SEM axis configuration via buttons instructions?
Here you could find instructions on how to set up the 2 SEM axes for different detents blocks.
If you want both detents and axis, first set up the number of detents properly, then activate the axis like here.
If you want both detents and axis, first set up the number of detents properly, then activate the axis like here.
-
- Posts: 5
- Joined: Fri Nov 26, 2021 9:10
Re: SEM axis configuration via buttons instructions?
My VKBDevCfg isnt giving me a find&autoconfig button... what do I do about that?
EDIT... I closed the program and reopend it for the 4th time, and that button appeared... Thanks Fallout9
EDIT... I closed the program and reopend it for the 4th time, and that button appeared... Thanks Fallout9
- fallout9
- Posts: 5160
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 207 times
- Been thanked: 1217 times
Re: SEM axis configuration via buttons instructions?
The button disappears after getting pressed. To get it shown again you have to press the Default button. If you're using any axes on your Gladiator NXT or module(s) you'll also need to recalibrate, as the Default button resets all settings.
Return to “Manuals and Howtos”
Who is online
Users browsing this forum: No registered users and 20 guests