VKB-SIM

Hi,
I've followed the instructions given here:
viewtopic.php?f=27&t=2728#p30648
and I now have the virtual toe brakes setup I believe, however I've lost the left and right axis on my Gate Cont slew, is this correct? did I miss a step?
Apologies there are a lot of posts on virtual toe brakes and naturally due to everyones varied setup no two are the same.

I'm running the Gunfighter Mk.III
T-rudder
MCG Pro
I do not have a twist unit.
plugged in via single black box.

thank you
Pete

edit:
Probably helps if i provide my settings...
https://i.imgur.com/Zqnv1E4.jpg

Ok,
I've been messing around here in VKBConfig, is there a way to swap the axis on the Master mode and gate cont? that way i can retain the gate cont for slew and remove the master mode axis?
I should be able to keep it as a POV button still in that instance shouldn't I?
in fact I should be able to keep the one axis perhaps for trim.
thanks

Check out this post. I think it will become clear what still needs to be done.

Hi,
Apologies for the delay in responding, I've actually followed this post, I get the same issue that fireshark has posted, all three axis are activated when I pull the brake lever, is this expected behavior or should I set the final axis to a different number perhaps?
it is possible it's expected considering my other setup tbh but confirmation would be good here as it's uncharted territory for me.

additionally, i've lost the slew control still on my joystick, the idea was to keep this if possible.
can anyone advise here? i'd love to set this up but it's proving difficult to simply remove the axis for master mode and keep gate cont.
thank you
Pete

edit:
Right it appears i can either lose master mode completely, or gate cont, so i've setup 3 profiles just for useage and can swap as needed.
cheers.

To understand what is not working for you and why, you need to show the settings from the configurator. Only then is it possible to suggest a solution, otherwise there is no way.