I just received my Gunfighter, and i'm searching for documentation about the black box.
I searched on the website and in the FAQ, but i can't find something which can describe the black box (button, led and connectors).
Blackbox manual ?
Moderator: AdminGroup
-
- Posts: 11
- Joined: Mon Aug 17, 2020 19:41
- Has thanked: 2 times
- Been thanked: 1 time
Re: Blackbox manual ?
Same question. What does the sys button do? What to the three LEDs on the right signify?
Re: Blackbox manual ?
All I've seen is this picture which describes the LED number in VKBConfig?
AFAIK, the leds just tell you if something is connected. But you can also program the LEDs to change based on shift state..etc
Someone who has a better understanding will have to reply. I barely understand any of the VKBConfig manual https://vkbcontrollers.com/wp-content/u ... _11_En.pdf
AFAIK, the leds just tell you if something is connected. But you can also program the LEDs to change based on shift state..etc
Someone who has a better understanding will have to reply. I barely understand any of the VKBConfig manual https://vkbcontrollers.com/wp-content/u ... _11_En.pdf
- fallout9
- Posts: 5182
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Blackbox manual ?
That's the proper schematic for the BB's LEDs. You could also identify them by going to the Test, then Misc tab, setting up the LED number and holding the mouse pressed on the Fast Test button - the LED will flash on your BB. You'll have to restart your device after this operation as the LEDs will be off.
Then you could go Global/ External/ LEDs tab and check each LED's function. In the attached screenshot I have LEDs 0 and 10 indicating the pitch axis in center in green and yellow colors, LED 0 blinking fast in blue when calibrating, LED 1 green when rudders are attached and so on.
Please note that before getting access to these tabs you'll have to open the zconfig.ini file, which is in the same folder with the configurator and add User=Developer under [User] section and Test Misc Enabled=1 under [Common] section.
Then you could go Global/ External/ LEDs tab and check each LED's function. In the attached screenshot I have LEDs 0 and 10 indicating the pitch axis in center in green and yellow colors, LED 0 blinking fast in blue when calibrating, LED 1 green when rudders are attached and so on.
Please note that before getting access to these tabs you'll have to open the zconfig.ini file, which is in the same folder with the configurator and add User=Developer under [User] section and Test Misc Enabled=1 under [Common] section.
Return to “Manuals and Howtos”
Who is online
Users browsing this forum: No registered users and 51 guests