VKB-SIM

This topic is clear viewtopic.php?f=27&t=2675 but not workings for my equipment configuration. Any suggestions?

If you show screenshots of your settings, then things will go much faster and more productively. Save your time and ours.

Sorry, it is impossible now, day after tomorrow will be. The config is default and the same, MCG Pro instead KG12 only.
If you don’t mind a couple of question before it will albe:
Should i apply exactly the http://ftp.vkb-sim.pro/Profiles/BlackBo ... _79_99.zip profile from previos post?
Which button is used for brakes activation in my MCG Pro?

You do not need to assign a brake button when changing the grip to the MCG.
She has a lever, which is much more convenient than a button. It is to this lever that virtual brakes are tied.
When changing the grip, the firmware must be changed and the previously made profile loaded (if it was configured and saved).
Not every airplane has separate brakes, there can only be a common lever. Therefore, there should be different profiles for such a case.
Check out this post, everything should be clear there.

Thanks a lot Ron61, will do and will report. It should be done

Some Actions report:
only Right Break works prorertly, when I press break lever (Axis Z) on stick and Right side of pedals the Slider 2 activates only. when I press break lever (Axis Z) on stick and Right side of pedals the Slider2 AND Slider1 activates simultaneosly

Pressing Left:

Pressing Right:


MY CONFIG Before:


Next After:

If it does not work or does not work as intended, then somewhere there is an error. It should be more attentive and then everything will turn out .

Thanks so much Ron!
My mistake
It’s perfect now, DCS Bf109 is alive again for me!

You're welcome.