VKB-SIM

Please follow this manual step by step (http://ftp.vkb-sim.pro/Documentations/Mamba%20W-MCG%20Pro%20quick%20guide%20EN.pdf).
1. Install the adapter PCB.
2. Connect the MCG Pro to Mamba base.
3. Download and unzip the VKB Device Configuration software (http://ftp.vkb-sim.pro/Programms/VKBDevCfg-C_v0_90_3_5.zip).
4. Download and unzip the firmware for Mamba w/ MCG Pro (http://ftp.vkb-sim.pro/Firmware/Mamba/BM-FM-VM_MSGP_v1_97_0.zip).
5. Load the firmware for your joystick. And don't forget to check the latest firmware on our websites.
6. Calibrate your joystick.
7. You are cleared for takeoff, have a nice flight.

Just a couple of questions

"Black Mamba don’t need to install adapter PCB. Skip to 5- 4."

What joystick is in the pictures? Black Mamba MkIII? Why then has it the PCB installed?

"For Black Mamba, replace the 6-pin plug with 4-pin plug."

Like physically removing the 6-pin plug from the 6-2 blue cable? Where would I put the 2-pin and new 4-pin side if I don't have the PCB installed? Isn't the idea a 6-4 cable?

Radsoc wrote:Just a couple of questions
....
"Black Mamba don’t need to install adapter PCB. Skip to 5- 4.".....

Adapter should be installed on " Fat Mamba" and "Black Mamba" as well.
Adapter was preinstalled on Vintage Mamba only .

Installed it and it works well. I rotated the joystick a bit for ergonomy so its weight makes it a bit off at the center in terms of calibration. Is it possible to rezero it at "rest"? Edit: Just recalibrated it.

With the Black Mamba Mk3 I picked firmware for "Fat Mamba". I guess "black mamba" is a version without the base buttons.

Wizzo doesn't detect the joystick, but the VKB config is ok.

The amount of axes and buttons is just insane now.