Please follow this manual step by step (http://ftp.vkb-sim.pro/Documentations/Mamba%20W-MCG%20Pro%20quick%20guide%20EN.pdf).
1. Install the adapter PCB.
2. Connect the MCG Pro to Mamba base.
3. Download and unzip the VKB Device Configuration software (http://ftp.vkb-sim.pro/Programms/VKBDevCfg-C_v0_90_3_5.zip).
4. Download and unzip the firmware for Mamba w/ MCG Pro (http://ftp.vkb-sim.pro/Firmware/Mamba/BM-FM-VM_MSGP_v1_97_0.zip).
5. Load the firmware for your joystick. And don't forget to check the latest firmware on our websites.
6. Calibrate your joystick.
7. You are cleared for takeoff, have a nice flight.
How to install Mamba w/ MCG Pro
Moderator: AdminGroup
- ZERO_Thunder
- Posts: 42
- Joined: Thu Apr 25, 2019 5:04
- Has thanked: 3 times
- Been thanked: 8 times
- Contact:
Re: How to install Mamba w/ MCG Pro
Just a couple of questions
"Black Mamba don’t need to install adapter PCB. Skip to 5- 4."
What joystick is in the pictures? Black Mamba MkIII? Why then has it the PCB installed?
"For Black Mamba, replace the 6-pin plug with 4-pin plug."
Like physically removing the 6-pin plug from the 6-2 blue cable? Where would I put the 2-pin and new 4-pin side if I don't have the PCB installed? Isn't the idea a 6-4 cable?
"Black Mamba don’t need to install adapter PCB. Skip to 5- 4."
What joystick is in the pictures? Black Mamba MkIII? Why then has it the PCB installed?
"For Black Mamba, replace the 6-pin plug with 4-pin plug."
Like physically removing the 6-pin plug from the 6-2 blue cable? Where would I put the 2-pin and new 4-pin side if I don't have the PCB installed? Isn't the idea a 6-4 cable?
- Zorik
- Posts: 57
- Joined: Tue Mar 11, 2014 11:19
- Location: Столица Негева
- Has thanked: 28 times
- Been thanked: 4 times
Re: How to install Mamba w/ MCG Pro
Radsoc wrote:Just a couple of questions
....
"Black Mamba don’t need to install adapter PCB. Skip to 5- 4.".....
Adapter should be installed on " Fat Mamba" and "Black Mamba" as well.
Adapter was preinstalled on Vintage Mamba only .
Re: How to install Mamba w/ MCG Pro
Installed it and it works well. I rotated the joystick a bit for ergonomy so its weight makes it a bit off at the center in terms of calibration. Is it possible to rezero it at "rest"? Edit: Just recalibrated it.
With the Black Mamba Mk3 I picked firmware for "Fat Mamba". I guess "black mamba" is a version without the base buttons.
Wizzo doesn't detect the joystick, but the VKB config is ok.
The amount of axes and buttons is just insane now.
With the Black Mamba Mk3 I picked firmware for "Fat Mamba". I guess "black mamba" is a version without the base buttons.
Wizzo doesn't detect the joystick, but the VKB config is ok.
The amount of axes and buttons is just insane now.
Return to “Manuals and Howtos”
Who is online
Users browsing this forum: No registered users and 28 guests