8 posts • Page 1 of 1
The stick does not know when you are at super cruise or if you are docking... The response curve is either working or it is not. You of course have to check the box on the physical axis to enable the response curve, and you need to press the Set button or nothing will have changed on-board the stick/base.
Atriden wrote:I finally found how to access the curves.https://imgur.com/a/h3zkIoo
However, I am not sure if it is working as intended as I am not experiencing any difference. I have checked the eq as suggested in the manual but it still wont apply.
Got any new suggestions ?
- You say you checked the Eq box, yet your screenshots show you didn't.
- Unless you have some really weird control setup, it looks like you are applying a curve to the wrong axis (if somehow the stick was not set to axes 1 and 2). If however axes 1 and 2 are really your stick's movement, then you have axes 1 and 2 mode set to relative... YOU DO NOT FLY WITH A RELATIVE AXIS. So unless you have some crazy setup, you have your settings all wrong. You should probably reset the device to default and start over again.
- When setting a curve, 128 corresponds to "full travel". If you put 100% as anything less than 128, you will not be able to achieve 100% of the axis.
Who is online
Users browsing this forum: No registered users and 1 guest