Relative Axis Mode - Master Mode (РЕЖИМ КБО) Hat Switch

Moderator: AdminGroup

User avatar
rrohde
Posts: 513
Joined: Thu Oct 08, 2015 9:28
Location: Oklahoma, USA
Has thanked: 480 times
Been thanked: 175 times

Relative Axis Mode - Master Mode (РЕЖИМ КБО) Hat Switch

Postby rrohde » Thu Dec 28, 2017 3:40

Hi guys,

VKB introduced relative axes to the MCG's Master Mode (РЕЖИМ КБО) hat. Relative axes are analog axes whose position stays where they are when you let go of the hat switch - even though the hat switch itself returns to center. Compare that to you standard analog axes that will return to center along with the physical hat switch when you let go of it (you can observe the behavior of these analog axes within the VKB JoyTester or the VKBdevCfg app).

The Master Mode (РЕЖИМ КБО) hat switch can toggle between POV mode and Analog mode by pressing on it.

To assign these relative analog axes to your simulation of choice, do the following using the Master Mode (РЕЖИМ КБО) hat:

1) Enter "axes" mode by long press on the Master Mode (РЕЖИМ КБО) hat switch
2) Center the axes by short press on the Master Mode (РЕЖИМ КБО) hat switch
3) Within your simulation of choice, get ready to assign your analog axes
4) To assign the horizontal axis, move the Master Mode (РЕЖИМ КБО) hat left/right for a few seconds until detected in the sim (relative mode takes longer compared to normal axes to reach the far end)
5) To assign the vertical axis, move the Master Mode (РЕЖИМ КБО) hat up/down for a few seconds until detected in the sim (relative mode takes longer compared to normal axes to reach the far end)

Done.

Return to “Manuals and Howtos”

Who is online

Users browsing this forum: No registered users and 5 guests