Gunfighter Mk.I gimbal operating quick guide

Moderator: AdminGroup

User avatar
UIV
Мастер
Posts: 4962
Joined: Mon Apr 17, 2006 16:33
Has thanked: 18 times
Been thanked: 249 times

Gunfighter Mk.I gimbal operating quick guide

Postby UIV » Fri Apr 28, 2017 11:21

The Gunfighters ship with cams #10 (soft center detent for both axes), and springs #20 (standard strength) factory installed.

The Gunfighters ship with the following springs:
#10 - soft
#20 - standard (factory installed)
#30 - medium
#40 - strong

The Gunfighter Pro comes with an additional spring to support the extension:
#50 - extra strong

The Gunfighters ship with the following cams:
#10 - soft center detent (factory installed)
#30 - center detent

The TM Warthog Adapter for Gunfighter ships with the following cam:
"W" - to support the added weight of the TM Warthog grip

Accessing the Gunfighter gimbal:
1) Disconnect the grip
2) Unscrew the 6 screws on the dust cover. Remove the dust cover
3) Unscrew the 4 screws on the bottom plate. Remove the bottom plate
4) Disconnect the 4-pin connector from the base
5) Unscrew the 4 screws on the top plate.
6) Remove the gimbal from the base.
7) When done, assemble in reverse order

Gunfighter Dry Clutch damper adjustment:
1) Rotate the copper nut to adjust the damper force. Attention! Do not exceed the tightening force of the damper!
2) Install the grip, check the operation and 'feel' of the gimbal. If necessary, re-adjust the damper to your liking

Replacing the standard strength spring (#20)
1) Use a pliers with a thin nose to install or remove the spring for each axis

Replacing the strong spring (#40, 50):
1) Unscrew the M4 nut (near ball bearing)
2) Press on the cam and carefully remove the ball bearing
3) Pay attention to the position of the washers near the ball bearing.
4) Replace the spring. If necessary, two springs can be installed simultaneously. Attention! Carefully install the springs. Careless installation may scratch the working surface of the cam.
5) Press on the cam and carefully install the ball bearing.
6) Install and tighten the M4 nut

Replacing the default cam (#10):

1) Remove the springs
2) Unscrew the M4 nut and detach the cam from the gimbal.
3) Pay attention to the position of the washers between the cam and the bearing.
4) Replace the cam, tighten the M4 nut.
5) Install the springs

Return to “Manuals and Howtos”

Who is online

Users browsing this forum: No registered users and 1 guest